CUTTING/ SLICING
Achieves efficient cutting.
Our temporary adhesives stick strongly even difficult-to-hold materials or peculiar shapes, and cause less damage to machined surface, allowing for easy cleaning. We are able to propose the optimum products under various conditions such as processing method and required accuracy.
ADFIX Series
Has strong adhesion. Good for small materials cutting. Less cloggings during cutting, so that provides stable fine result for high load cutting. Cleaning can be done by alkaline detergents or alcohols. Since main ingredients are heat-hardening resin, good stable effect can be attained by controlling heating temperature and working time.
SKY WAX Series
Has been used for a long time in grinding, lapping and polishing processes. Wide variety types are available from high to low Softening point and Viscosity. Good for high precision process. Can not be dissolved by alkaline agents or alcohols well, but Hydrocarbon solvents can clean SKYWAX well.
ALCOWAX Series
Good for a variety of processes, the same as SHIFTWAX. Less attacked by water soluble alkaline coolants as it could not be dissolved by alkaline agents well. Cleaning can be done by alcohols such as Isopropyl alcohol, acetone, or hydrocarbon solvents.
SHIFTWAX Series
Good for high precision processes of cutting, grinding, lapping, polishing, etc. Cleaning can be done by alkaline detergents, alcohols such as isopropyl alcohol as well as acetone or hydrocarbon solvents.
AQUAWAX Series
One type is cleaned by hot water, the other is cleaned by water at room temperature. Cleaning process is easier and simpler so that could improve working conditions and waste treatement could be easier.
W, Q, U, B BOND
Two-component type epoxy adhesives for slicing ingots or blocks. They are removable by hot water. Many types such as quick cure type and strong adhesion type are available for your process. Mixing ratio of resin and hardener is 1:1 or 2:1.
SUNBEAM (Resin type slicing beam)
The dedicated resin made carrier that replaces carbon as a slicing beam for wire saw process. No need to use glass carrier for insulation. Good adhesion suitability with our epoxy adhesives.
NANOBLOCKER Series
By adding a small amount of NANOBLOCKER into DI water at dicing process, it prevents from adhering contaminations on workpiece surface, and improve cutting effect. Also prevents from pad corrosion. We have two types: recycle type and disposal type.
NS-COOLANT Series
Lubricant NS-COOLANT Y and SL-1 are good for diamond slurry. NS-COOLANT AD-NA and CS-5 are weak alkalescent types without dissolving our ADFIX and SHIFTWAX used in OD blade cutting process.
DEVEL
Strong cleaning power is suitable for removing our ADFIX and SHIFTWAX as well as greases and contaminations on polishing plate. Less foaming type, DEVEL A, is also available.
RUNGEL F
Less metal-etching cleaner. Due to the antirust effet, good for wax cleaning in magnetic material process.
NORMAL A
By it's strong surfactant effect, good for removing greases, abrasives and waxes well.
NIKKASOLE
Cleaning various waxes such as SKYWAX, ALCOWAX and SHIFTWAX. Good for rough cleaning of oil type Coolant. Friendly working condition can be maintained due to high flash point of 73℃ and less odor. LC type is good for pitch type wax.
EMUNIKKA
Removes oil by strong emulsifying effect. EMUNIKKA #2 is weak alkali type and used at room temperature. EMUNIKKA #55 is strong alkali type and used by heating. #55 is good for cleaning our ADFIX as well.
By selecting a keyword, related products are shown.